Displaying And Maintaining Information Center; Setting To Output System Information To The Snmp Nms - 3Com 4210 PWR Configuration Manual

462 C 40: I
HAPTER NFORMATION
Setting to Output
System Information to
the SNMP NMS
Displaying and
Maintaining
Information Center
C
ENTER
Table 351 Set to output system information to the log buffer
Operation
Configure the output rules of
system information
Set the format of time stamp
in the output information
Table 352 Set to output system information to the SNMP NMS
Operation
Enter system view
Enable the information center info-center enable
Enable information output to
the SNMP NMS
Configure the output rules of
system information
Set the format of time stamp
in the output information
n
To send information to a remote SNMP NMS properly, related configurations are
required on both the switch and the SNMP NMS.
After the above configurations, you can execute the display commands in any
view to display the running status of the information center, and thus validate your
configurations. You can also execute the reset commands in user view to clear the
information in the log buffer and trap buffer.
Command
info-center source {
modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity |
state state } ]*
info-center timestamp { log
| trap | debugging } { boot |
date | none }
Command
system-view
info-center snmp channel {
channel-number |
channel-name }
info-center source {
modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity |
state state } ]*
info-center timestamp { log
| trap | debugging } { boot |
date | none }
Description
Optional
Refer to Table 345 for the
default output rules of system
information.
Optional
By default, the time stamp
format of the output log
information is date.
Description
-
Optional
Enabled by default.
Optional
By default, the switch outputs
trap information to SNMP
through channel 5.
Optional
Refer to Table 345 for the
default output rules of system
information.
Optional
By default, the time stamp
format of the information
output to the SNMP NMS is
date.