Configuring Edge-Ports; Save Configuration; Configure Additional Switch - Dell Cisco Catalyst 3850 PS Series Configuration Manual

Sans

Table of Contents

2.7

Configuring edge-ports

Perform this step for each individual port that is connected to a storage controller or a host interface port, or

specify a range of ports to configure. This section enables link-level flow control (802.3x), portfast, and service

policy.

Switch(config)#interface range gigabitEthernet 1/0/1 – 24

Note: Configure all the 48 ports for the 48 port model of the switch using the following command.

# interface range gigabitEthernet 1/0/1 – 48

Switch(config-if-range)#flowcontrol receive on

Switch(config-if-range)#spanning-tree portfast

Switch(config-if-range)#service-policy output single-queue-buffer

Switch(config-if-range)#switchport

Switch(config-if-range)#no shutdown

Switch(config-if-range)#exit

Switch(config)#exit

2.8

Switch#copy running-config startup-config

2.9

Repeat the commands from sections 2.1 through 2.8 to configure the second switch.

Cisco Catalyst 3850 Switch Configuration Guide for Dell PS Series SANs | SCG3299

Table of Contents