Run Command Source Setting - Hitachi WJ200 Series Instruction Manual

Run Command Source Setting – For parameter A002, the following table provides a
further description of each option, and a reference to other page(s) for more information.
Code
01
Control terminal – The [FW] or [RV] input terminals control
Run/Stop operation
02
Keypad Run key – The Run and Stop keys provide control
03 ModBus network input – The network has a dedicated coil for
Run/Stop command and a coil for FW/RV
04 Option – Select when an option card is connected and use the
frequency source from the option
A001/A002 Override Sources – The inverter allows some sources to override the setting
for output frequency and Run command in A001 and A002. This provides flexibility for
applications that occasionally need to use a different source, leaving the standard
settings in A001/A002.
The inverter has other control sources that can temporarily override the parameter
A001 setting, forcing a different output frequency source. The following table lists all
frequency source setting methods and their relative priority ("1" is the highest priority).
A001
Priority
1 [CF1] to [CF4] Multi-speed terminals
2 [OPE] Operator Control intelligent input
3 [F-TM] intelligent input
4 [AT] terminal
A001
5
Frequency source setting
The inverter also has other control sources that can temporarily override the parameter
A002 setting, forcing a different Run command source. The following table lists all Run
command setting methods and their relative priority ("1" is the highest priority).
A002
Priority
1 [OPE] Operator Control intelligent input
2 [F-TM] intelligent input
A002
3

Run command source setting

Run Command Source
Frequency Source Setting Method
Run Command Setting Method
3−13
Refer to page(s)...
4-16
2-23
B-24
(manual of each
option)
Refer to page...
4-17
4-35
4-42
4-28
3-10
Refer to page...
4-35
4-42
3-10