Hitachi WJ200 Series Instruction Manual page 173

3−92
Option Terminal
Code Symbol
22 DSE
23 POK
24
FA4
25 FA5
26 OL2
27 ODc
28 OIDc
31 FBV
32
NDc
33
LOG1
34
LOG2
35
LOG3
39
WAC
40
WAF
Output Function Summary Table
Function Name
Speed Deviation
Excessive
Positioning Completion
Frequency Arrival Type
4–Over frequency
Frequency Arrival Type
5–Set frequency
Overload Advance
Notice Signal 2
Analog Voltage Input
Disconnect Detection
Analog Current input
Disconnect Detection
PID Second Stage
Output
Network Disconnect
Detection
Logic Output Function 1
Logic Output Function 2
Logic Output Function 3
Capacitor Life Warning
Signal
Cooling Fan Warning
Signal
Description
OFF Output frequency is higher than the threshold
specified in C063
ON Deviation of speed command and actual speed
exceeds the specified value P027.
OFF Deviation of speed command and actual speed
does not exceed the specified value P027.
ON Positioning is completed
OFF Positioning is not completed
ON When output to motor is at or above the set freq.,
even if in accel (C045) or decel (C046) ramps
OFF When output to motor is OFF, or at a level below the
set frequency
ON When output to motor is at the set frequency, during
accel (C045) and decel (C046).
OFF When output to motor is OFF, or is not at a level of
the set frequency
ON When output current is more than the set threshold
(C111) for the overload signal
OFF When output current is less than the set threshold
for the deviation signal
When the [O] input value < B070 setting (signal loss
ON
detected)
OFF When no signal loss is detected
When the [OI] input value < B071 setting (signal loss
ON
detected)
OFF When no signal loss is detected
ON Transitions to ON when the inverter is in RUN Mode
and the PID Process Variable (PV) is less than the
Feedback Low Limit (C053)
OFF Transitions to OFF when the PID Process Variable
(PV) exceeds the PID High Limit (C052), and
transitions to OFF when the inverter goes from Run
Mode to Stop Mode
ON When the communications watchdog timer (period
specified by C077) has time out
OFF When the communications watchdog timer is
satisfied by regular communications activity
When the Boolean operation specified by C143 has
ON
a logical "1" result
When the Boolean operation specified by C143 has
OFF
a logical "0" result
When the Boolean operation specified by C146 has
ON
a logical "1" result
When the Boolean operation specified by C146 has
OFF
a logical "0" result
When the Boolean operation specified by C149 has
ON
a logical "1" result
When the Boolean operation specified by C149 has
OFF
a logical "0" result
ON Lifetime of internal capacitor has expired.
OFF Lifetime of internal capacitor has not expired.
ON Lifetime of cooling fan has expired.