Hitachi WJ200 Series Instruction Manual page 405

C−24
Func.
Code
Reset selection
C102
Restart mode after reset
C103
UP/DWN clear mode
C104
EO gain adjustment
C105
AM gain adjustment
C106
AM bias adjustment
C109
Overload warning level 2
C111
Output [11] on delay
C130
Output [11] off delay
C131
Output [12] on delay
C132
Output [12] off delay
C133
Relay output on delay
C140
Relay output off delay
C141
Logic output 1 operand A
C142
Logic output 1 operand B
C143
Logic output 1 operator
C144
Logic output 2 operand A
C145
Logic output 2 operand B
C146
"C" Function
Name
Determines response to Reset
input [RS].
Four option codes:
00...Cancel trip state at input
signal ON transition, stops
inverter if in Run Mode
01...Cancel trip state at signal
OFF transition, stops inverter
if in Run Mode
02...Cancel trip state at input ON
transition, no effect if in Run
Mode
03...Clear the memories only
related to trip status
Determines the restart mode after
reset is given, three option codes:
00...Start with 0 Hz
01...Start with freq. matching
02...Start with active freq.
matching
Freq. set value when UDC signal is
given to the input terminal, two
option codes:
00...0 Hz
01...Original setting (in the
EEPROM memory at power
on)
Set range is 50 to 200%
Set range is 50 to 200%
Set range is 0 to 100%
Sets the overload warning signal
level between 0% and 200% (from 0
to two time the rated current of the
inverter)
Set range is 0.0 to 100.0 sec.
Set range is 0.0 to 100.0 sec.
Set range is 0.0 to 100.0 sec.
All
available for logic (discrete) outputs
except LOG1 to LOG3, OPO, no
Applies a logic function to calculate
[LOG] output state,
Three options:
00...[LOG] = A AND B
01...[LOG] = A OR B
02...[LOG] = A XOR B
All
available for logic (discrete) outputs
except LOG1 to LOG3, OPO, no
Description
the programmable functions
the programmable functions
Run Defaults
Mode Lnitial
Units
Edit
data
00 −
00 -
00 -
100. %
100. %
0. %
Rated A
current
x 1.15
0.0 Sec.
0.0 Sec.
0.0 Sec.
0.0 Sec.
0.0 Sec.
0.0 Sec.
00 −
00 −
00 −
00 −
00 −