Standard Keypad Programming; Programming Using The Cf Switches - Hitachi WJ200 Series Instruction Manual

4−18
While using the multi-speed capability, you can monitor the present frequency with
monitor function
NOTE: When using the Multi-speed Select settings CF1 to CF4, do not display
parameter F001 or change the value of
running). If it is necessary to check the value of
instead of F001.
D001
There are two ways to program the speeds into the registers

1. Standard keypad programming:

a. Select each parameter
b. Press the SET key to view the parameter value.
c. Use the
d. Use the SET key to save the data to memory.
2. Programming using the CF switches. Set the speed by following these steps:
a. Turn the Run command OFF (Stop Mode).
b. Turn inputs ON to select desired Multi-speed. Display the value of
digital operator.
c. Set the desired output frequency by pressing the
d. Press the SET key once to store the set frequency. When this occurs,
F001
e. Press the SET key once to confirm that the indication is the same as the set
frequency.
f. Repeat operations in 2. a) to 2. e) to set the frequency of other Multi-speeds. It
can be set also by parameters
during each segment of a multi-speed operation.
D001
A020
and keys to edit the value.
indicates the output frequency of Multi-speed n.
while the inverter is in Run Mode (motor
F001
during Run Mode, please monitor
F001
to A035.
to in the first procedure 1. a) to 1. d).
A020 A035
to A035:
A020
on the
F001
and keys.