Warning Codes - Hitachi WJ200 Series Instruction Manual

Error
Code
Rotating
Blinking
Reset is not allowed in 10 second after trip.
NOTE:
When error E08, E14 and E30 occur, reset operation by RS terminal or STOP/RESET
NOTE:
key is not accepted. In this case, reset by cycling power. If still same error occurs, perform
initialization.

Warning Codes

If set parameter is conflicted to other parameters, warning code is displayed as follows.
Warning
Code
001 Frequency upper limit (A061)
002
Frequency lower limit (A062)
Output Frequency setting (F001)
005
Multi-speed freq. 0 (A020)
Output Frequency setting (F001)
015
Multi-speed freq. 0 (A020)
025
Frequency lower limit (A062)
031 Start frequency (A082)
032
Start frequency (A082)
035
Start frequency (A082)
036 Start frequency (A082)
037
Start frequency (A082)
Name
Reset RS input is ON or STOP/RESET key is pressed.
If input voltage is under the allowed level, inverter
Undervoltage
shuts off output and wait with this indication.
This indication is displayed after tripping before
Waiting to restart
restarting.
Restricted operation
Commanded RUN direction is restricted in b035.
command
Trip history
Trip history is being initialized.
initializing
No data
No trip/waning data exists.
(Trip monitor)
Communication Communication between inverter and digital
error operator fails.
Auto-tuning
Auto-tuning is completed properly.
completed
Auto-tuning error Auto-tuning fails.
Descriptions
Warning condition
> Max. Frequency (A004)
>
Max. Frequency (A004)
>
Max. Frequency (A004)
>
Frequency upper limit (A061)
Output Frequency setting (F001)
>
Multi-speed freq. 0 (A020)
> Frequency upper limit (A061)
>
Frequency lower limit (A062)
Output Frequency setting (F001)
>
Multi-speed freq. 0 (A020)
> Multi-speed freq. 1-15 (A021-A035)
>
Jogging frequency (A038)
6−11