Monitor The Frequency Command Source And Run Command Source - Hitachi WJ Series User Manual

Chapter 10
10.3.5

Monitor the Frequency Command Source and RUN Command Source

 How to check if RUN command source is wrong with what was set?
Q
 How to check if the frequency command source is wrong with what was set?
A Frequency input source monitor [d062]
 Displays the currently enabled frequency command source.
 The frequency command source varies depending on the status of the input terminal function
!
and other functions as well as the setting of "frequency reference selection [A001]
refer to "9.2 Selecting Frequency Command".
Code
Frequency input source
[d062]
monitor
RUN command input source monitor [d063]
A
 Displays the currently enabled RUN command source.
 The RUN command source varies depending on the status of the input terminal function and
!
other functions as well as the setting of "RUN command input source selection [A002]
to "9.1 Selecting RUN Command and Alarm Reset" for more information.
Code
RUN command input
[d063]
source monitor
*1. "2nd-motor control [SET]" target parameter. The second control parameter is also subject to setting.
Item
Keypad (Multi-speed 0)
Multi-speed 1 to 15
Jogging
Modbus communication
Option
External POT
Pulse input
Calculation function result
EzSQ
[Ai1] terminal (analog voltage) input
[Ai2] terminal (analog current) input
[Ai1] terminal input + [Ai2] terminal input
Item
Control terminal
Keypad (RUN-key)
Modbus communication
Option
10-3-5
Monitor Functions
Description
Description
*1
". For details,
Data
00
01 to 15
16
18
19
21
22
23
24
25
26
27
*1 ". Refer
Data
01
02
03
04