Epson ColorPage EPL-C8000 Service Manual page 344

EPSON EPL-C8000
Table 5-17. Warning Message List (3/4)
o u u u u Toner Low (continued)
Solution Do one or more of the following to clear the warning message.
Press the Continue button.
1.
Perform a Reset operation.
2.
Replace the indicated toner cartridge with a new one.
3.
o Warning Photocondctr
LED Message No effect on LED state.
Explanation The photoconductor unit is approaching the end of its life. The
engine's detection system calculates the remaining
lifetime, and generates this message when the number of
pages left approaches:
Color print: 1,125 pages (A4, 4.5% duty)
Black print: 4,500 pages (A4, 4.5% duty)
Solution It is recommended that the photoconductor unit be replaced
when this message appears (although it is possible to
continue using the existing unit until the "Replace
Photocondctr" error occurs). Do any of the following to clear
the warning message.
Press the Continue button.
1.
Perform a Reset operation.
2.
Replace the photoconductor unit with a new one.
3.
o Waste T Box Nearfull
LED Message No effect on LED state.
Explanation The Waste Toner Collector is almost full. (The engine's
detection system calculates the level of waste toner, and
generates this message when the Waste Toner Collector is
full.
Solution It is recommended that the Waste Toner Collector be
replaced when this message appears (although it is possible
to continue using the existing box until the "Replace Waste T
Box" error occurs). Do any of the following to clear the
warning message.
Press the Continue button.
1.
Perform a Reset operation.
2.
Replace the
3.
Chapter 5 TROUBLESHOOTING
with a new one.
Waste Toner Collector
Table 5-18. Warning Message List (4/4)
o Oil Roll Near Empty
LED Message No effect on LED state.
Explanation The fuser oil is running low. (The engine's detection system
calculates the remaining level of fuser oil, and generates
this message when it determines that the fuser oil will run out
after printing 1,000 more pages (A4, 5% duty, black print:color
print=1:1).
Solution It is recommended that the Fuser Oil Roll be replaced when
this message appears (although it is possible to continue
using the existing oil roll until the "Replace Oil Roll" error
occurs). Do any of the following to clear the warning
message.
Press the Continue button.
1.
Perform a Reset operation.
2.
Replace the
3.
o Maintenance Req hhhh *1
LED Message No effect on LED state.
Explanation A warning condition that cannot be corrected by the user has
occurred, and this condition requires maintenance.
Specifically, one or more of the internal units that cannot be
replaced by the user is nearing the end of its life.
Solution Although the user can continue to operate the printer until the
"Service Req effff" error occurs, the user should write down
the warning code and call for service before the service
required state is reached; otherwise the printer may stop
working partway through a print job. Do either of the following
to clear the warning message.
Press the Continue button.
1.
Perform a Reset operation.
2.
o Menus Locked
LED Message No effect on LED state.
Explanation Panel setting change was attempted though the "Panel Lock"
is able in EJL.
Solution Press Continue button.
Rev. B
with a new one.
Fuser Oil Roll
5-10