Epson ColorPage EPL-C8000 Service Manual page 470

EPSON EPL-C8000
10) Remove a total of 4 spacers from where the toner cartridges are
inserted.
11) Unpack the TONER CARTRIDGEs. Hold both ends of each
cartridge and shake several times.
12) Rotate the ROTARY FRAME ASSEMBLY and install the
TONER CARTRIDGEs.
NOTE:Install each TONER CARTRIDGE by matching the toner
color with the color of the installation window.
NOTE:To rotate the ROTARY FRAME ASSEMBLY, press up the
ROTARY LATCH LEVER and rotate the ROTARY KNOB
ASSEMBLY clockwise.
13) Close the FRONT COVER ASSEMBLY.
14) Open the MAIN P/H ASSEMBLY. Remove the two spacers from
the MAIN P/H ASSEMBLY.
15) Close the MAIN P/H ASSEMBLY.
16) Open the FUSER ASSEMBLY. Remove the packing materials
(expanded polystyrene).
17) Open the OIL ROLL ASSEMBLY. Remove the protective cover
and locking pins.
NOTE:Keep the OIL ROLL ASSEMBLY on a level position as it is
installed in the printer. The internal fuser oil may leak if the
OIL ROLL ASSEMBLY is in a vertical or inclined position.
NOTE:Do not touch the surface of the white roll in the OIL ROLL
ASSEMBLY because the white roll is filled with fuser oil.
Chapter 6 MAINTENANCE
18) Install the OIL ROLL ASSEMBLY above the FUSER
ASSEMBLY.
19) Close the FUSER ASSEMBLY.
20) Draw out the UNIVERSAL TRAY. Remove the packing material
(expanded polystyrene) from the UNIVERSAL TRAY.
21) Press down the BOTTOM PLATE ASSEMBLY in the
UNIVERSAL TRAY and lock it at the bottom.
22) Put paper in the UNIVERSAL TRAY.
NOTE:When putting paper in the tray, be sure to:
- Align the four corners of the paper before putting it in the tray.
- Place all paper under the pawls at the front right corner of the
tray.
- Set the paper guide corresponding to the paper size.
23) Push in the UNIVERSAL TRAY.
24) Put paper in the MSI ASSEMBLY.
NOTE:When putting paper in the tray, be sure to:
- Align the four corners of the paper before putting it in the tray.
- Set a stack of paper under the stopper in the front right corner
of the tray.
- Set the paper guide corresponding to the paper size.
25) Connect the power cord.
26) Turn on the printer by the power switch.
27) Run a test print from each paper cassette to confirm that the
printer works fine.
28) Connect the printer to the PC and send print data to the printer.
Rev. B
6-17