Pick Up Solenoid Removal (Pl4.2.21) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.7.10 PICK UP SOLENOID Removal (PL4.2.21)

1. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
2. Remove the MSI ASSEMBLY. (See Section 3.2.7.2.)
3. Remove the MSI REAR COVER. (See Section 3.2.7.4.)
4. Disconnect the connector (P/J201B) for the PICK UP SOLENOID
and release the harness from the clamp.
5. Remove the screw (gold, tapped, 8mm) securing the PICK UP
SOLENOID and remove it.
n When routing the harness, make sure it is not touching
any gear.
n When installing the PICK UP SOLENOID, be sure to
engage the notch on the PICK UP CAM GEAR and the
arm of the PICK UP SOLENOID securely.
n After installing the PICK UP SOLENOID, check that the
notch on the PICK UP CAM GEAR is held at the arm of
the PICK UP SOLENOID. (with the PICK UP ROLL top
and the cam of the PICK UP CAM bottom)
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-36. PICK UP SOLENOID Removal
Revision B
3-34