Specifications; Basic Specifications - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

1.2 Specifications

This section describes specifications for this printer.

1.2.1 Basic Specifications

o Method:
Semi-conductive laser beam scanning and dry
electrophotographic process
o Resolution:
600 DPI
o Print mode:
n B/W mode:
Standard monochrome print mode that supports
the fastest speed.
n Color mode:
Color mode which uses the color toner of Y, M, C,
and BK.
o Speed mode:
n Standard mode:
Transports paper at the highest speed
supported by the printer.
n Half speed mode: Low speed mode that enables better fusing
for thick paper (over 105g/m
and OHP sheet.
o Print Speed:
See Table 1-1.
Chapter 1 PRODUCT DESCRIPTIONS
Print mode
B/W
Color
Notes:
*1. In this mode, the printer prints tow print images on the IBT belt and
the images are transferred in sequence onto two sheets of paper. It
is available for LT/A4 (LEF) or smaller.
*2. [LEF, or Long Edge Feed]
The longer edge of the paper is the top toward the paper feed direction.
[SEF, or Short Edge Feed]
The shorter edge of the paper is the top toward the paper feed direction.
o First print*:
- Face-up B/W:
- Face-down B/W:
NOTE:Fist print is defined as the duration taken after receiving the
2
) envelopes,
o Warm-up time:
Table 1-1. Speed Mode
Speed mode LT/A4 LEF 2UP (*1)
Standard mode 16 PPM or more
Half speed mode 2.7 PPM or more
Standard mode 4 PPM or more
half speed mode 1.8 PPM or more
20 seconds or less (LT/A4 LEF)
Color: 42.6 seconds or less (LT/A4 LEF)
24.9 seconds or less (LT/A4 LEF)
Color: 47.6 seconds or less (LT/A4 LEF)
start command until outputting the first print. It is applicable
when a feeder is selected in the standard mode. (Not applied
during the process control operation.)
Within 300 seconds
(at 22 degree Celsius, 58% Rh, rated voltage)
Rev. B
B(LD)/A3 SEF (*2)
8PPM or more
1.3PPM or more
2PPM or more
0.9PPM or more
1-3