Cleaner Cam Assembly Removal (Pl9.4.26) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.12.18 CLEANER CAM ASSEMBLY Removal (PL9.4.26)

1. Remove the EXIT TRAY ASSEMBLY. (See Section 3.2.13.1.)
2. Remove the OIL ROLL ASSEMBLY. (See Section 3.2.12.1.)
3. Remove the FUSER ASSEMBLY. (See Section 3.2.12.2.)
4. Remove the MAIN FUSER ASSEMBLY. (See Section 3.2.12.3.)
5. Remove the CLEANER CAM SOLENOID. (See Section 3.2.12.17.)
6. Remove 2 screws (gold, tapped, 10mm) securing the FUSER
FRONT RAIL, and remove the FUSER FRONT RAIL from the
FUSER TRAY ASSEMBLY.
NOTE: When removing the CLEANER CAM in the following step, be
careful not to drop and lose the CLEANER CAM PIN.
7. Remove the E-ring securing the CLEANER CAM and remove the
CLEANER CAM, CLEANER CAM PIN, CLN CAM BEARING-F.
8. Pull out the CLEANER CAM ASSEMBLY backward and remove tit
along with the CLN CAM BEARING-F.
9. Remove the CLN CAM BEARING-F from the CLEANER CAM
ASSEMBLY.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-111. CLEANER CAM ASSEMBLY Removal
When installing the both right and left cams, set them in
the same proper direction.
Revision B
3-93