Msi Top Cover Assembly Removal (Pl4.2.4) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.7.5 MSI TOP COVER ASSEMBLY Removal (PL4.2.4)

1. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
2. Remove the MSI ASSEMBLY. (See Section 3.2.7.2.)
3. Remove the MSI FRONT COVER. (See Section 3.2.7.4.)
4. Remove the MSI REAR COVER. (See Section 3.2.7.3.)
NOTE: In the following step, MSI TOP COVER ASSEMBLY is kept
connected with MSI FRAME by a harness. Therefore, do not
leave them too far.
5. Remove 2 screws (silver, tapped, 14mm) securing the MSI TOP
COVER ASSEMBLY, and remove the MSI TOP COVER
ASSEMBLY along with the MSI HARNESS COVER from the MSI
FRAME.
6. Release 2 hooks securing the MSI HARNESS COVER to the MSI
TOP COVER ASSEMBLY, and remove the MSI HARNESS
COVER.
7. Disconnect 2 connectors P/J203 and P/J204 (for the MSI EDGE
SENSOR and MSI SHORT N/P SENSOR, respectively), and
remove the MSI TOP COVER ASSEMBLY.
When installing the MSI TOP COVER ASSEMBLY, make
sure that the harness is not caught between the MSI TOP
COVER ASSEMBLY and MSI HARNESS COVER.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-31. MSI TOP COVER ASSEMBLY Removal
Revision B
3-30