1. Manuals
  2. Brands
  3. Epson Manuals
  4. Printer
  5. ColorPage EPL-C8000
  6. Quick reference

Epson ColorPage EPL-C8000 Quick Reference

Epson epl-c8000: quick start
Hide thumbs Also See for ColorPage EPL-C8000:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Service Manual, User Manual

Advertisement

Table of Contents
loading

Related Manuals for Epson ColorPage EPL-C8000

Summary of Contents for Epson ColorPage EPL-C8000

  • Page 2: Replacing Consumable Products

    Replacing Consumable Products You need to replace the following consumable products when you are given a notice message on the control panel display or in EPSON Status Monitor 2. Toner Cartridge (Yellow) Toner Cartridge (Magenta) Toner Cartridge (Cyan) Toner Cartridge (Black)

  • Page 3: Replacing The Photoconductor Unit

    If you need to replace another cartridge, repeat steps 2 to 5. Close the front cover. Replacing the photoconductor unit Turn off the printer and open the front cover. Note: When replacing the photoconductor unit, make sure to turn off the printer.
  • Page 4 When replacing the photoconductor unit, avoid exposing it to room light any longer than necessary, Drum Hold the handle at the top of the photoconductor unit and place the unit on the guide rails. Insert it all the way into the printer.

  • Page 5: Replacing The Waste Toner Collector

    Turn the small lever left. Small lever Turn the large lever clockwise 90 degrees. Then close the front cover. Replacing the waste toner collector Open the front cover. Grasp the handle and tab of the waste toner collector to release the lock. Then pull out the collector.

  • Page 6: Replacing The Fuser Oil Roll

    Warning: Be careful not to touch the fuser, which is marked CAUTION! HIGH TEMPERATURE or the adjoining areas. If the printer has been in use, the fuser and the area around it can be very hot. Take a new fuser oil roll from the box and remove the cover and two shipping pins.

  • Page 7: Clearing The Paper Cassette

    Warning: Be careful not to touch the fuser, which is marked CAUTION! HIGH TEMPERATURE or adjoining areas. If the printer has been in use, the fuser and the area around it can be very hot. Clearing the paper cassette Pull the paper cassette out slowly until it stops.

  • Page 8: Clearing The Mp Tray

    Clearing the MP tray Pull the jammed paper out gently. Pull the paper path unit out until it stops. Open the cover inside the unit by grasping the handle and pulling upwards. Cover MP tray Paper path unit Turn the knob on the unit. The jammed paper comes out.

  • Page 9: Clearing The Fuser Unit

    Be careful not to touch the fuser, which is marked CAUTION! HIGH TEMPERATURE or the adjoining areas. If the printer has been in use, the fuser and the area around it can be very hot. Reattach the fuser oil roll as soon as you clear the jammed paper.

  • Page 10: Clearing The Output Path Cover

    Remove all jammed paper. If paper has jammed at the top of the output path, gently lift it up. If it has jammed near the bottom of the output path cover, carefully pull it out of the printer. Output path cover Close the output path cover.

  • Page 11: Control Panel Messages

    Sheet facing the wrong direction or with the wrong side up, or you tried to load a transparency other than EPSON Color Laser Transparencies. The printer stops loading in order to avoid damage. You must clear any jammed sheets from the MP tray and paper path unit.
  • Page 12 Illegal Aux I/F The printer cannot Card communicate with the installed optional interface card. Turn off the printer and remove the card, then reinstall Illegal DIMM A The printer cannot read the installed optional DIMM. Turn off the printer and remove the DIMM.
  • Page 13 You need to clear any jammed paper from the MP tray and paper path unit. Maintenance A part inside the printer need Req XXXX to be replaced. Contact your dealer and report what XXXX: number (XXXX) appears.
  • Page 14 Replace it with a new fuser oil roll. Replace The photoconductor unit has Photocondctr reached the end of its service life. Turn off the printer, then remove the photoconductor unit and install the new photoconductor unit. Replace Waste T The waste toner collector has become full.
  • Page 15 XXXX Toner Out There is no toner remaining in the indicated (XXXX) toner XXXX: cartridge(s). Replace it with Letter(s) of Y, M, C, and/or K is the new toner cartridge. indicated. Copyright © 1998 by SEIKO EPSON CORPORATION, Nagano, Japan...

Table of Contents