Pressure Roll Removal (Pl9.2.9) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.12.11 PRESSURE ROLL Removal (PL9.2.9)

1. Remove the EXIT TRAY ASSEMBLY. (See Section 3.2.13.1.)
2. Remove the OIL ROLL ASSEMBLY. (See Section 3.2.12.1.)
3. Remove the FUSER ASSEMBLY. (See Section 3.2.12.2.)
4. Remove the MAIN FUSER ASSEMBLY. (See Section 3.2.12.3.)
5. Remove the FUSER UPPER ASSEMBLY. (See Section 3.2.12.4.)
6. Remove the H/R HEATER. (See Section 3.2.12.5.)
7. Remove the P/R HEATER. (See Section 3.2.12.6.)
8. Remove the LOWER GUIDE ASSEMBLY. (See Section 3.2.12.7.)
9. Remove the UPPER GUIDE ASSEMBLY. (See Section 3.2.12.9.)
10. Remove the HEAT ROLL. (See Section 3.2.12.10.)
11. Remove the screw (gold, 5mm) securing the FUSER INLET PLATE
and remove the FUSER INLET PLATE.
NOTE: In the following step, be careful not to damage the
PRESSURE ROLL surface.
12. Lift up the PRESSURE ROLL along with the P/H BEARING on the
front and rear ends, then remove the P/R BEARING from the
PRESSURE ROLL.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-103. PRESSURE ROLL Removal
After installing the PRESSURE ROLL, perform the
adjustment "NIP adjustment of the MAIN FUSER
ASSEMBLY". (See Section 3.3.1.)
Revision B
3-86