Front Cover Open; Exit Cover Open - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000
Table 5-8. Error Message List (3/9)
o Insert Waste T Box
LED status On Line = off, Continue = off
Explanation The Waste Toner Collector is not installed.
Solution Open the front cover, install the Waste Toner Collector, and close
the cover to clear the error.
o Insert Oil Roll
LED status On Line = off, Continue = off
Explanation The Fuser Oil Roll is not installed.
Solution Open the front cover, install the Fuser Oil Roll, and close the
cover to clear the error.
o Wrong Photoconductor
LED status On Line = off, Continue = off
Explanation Incorrect photoconductor unit is installed.
Solution Open the Fuser Unit, remove the old photoconductor unit, install
the correct photoconductor unit, and close the Fuser Unit. Turn
the printer off and back on.
o Photocondctr Trouble
LED status On Line = off, Continue = off
Explanation The Photoconductor unit is not working properly.
Solution Open the front cover, replace the photoconductor unit, and close
the cover to clear the error.
o Front Cover Open
LED status On Line = off, Continue = off
Explanation The front cover is open.
Solution Close the cover to clear the error.
o Exit Cover Open
LED status On Line = off, Continue = off
Explanation The exit cover is open.
Solution Close the cover to clear the error.
o Fuser Unit Open
LED status On Line = off, Continue = off
Explanation The fuser unit is open.
Solution Close the unit to clear the error.
Chapter 5 TROUBLESHOOTING
Table 5-9. Error Message List (4/9)
o Paper Unit Open
LED status On Line = off, Continue = off
Explanation The paper feed unit is open.
Solution Close the unit to clear the error.
o Feeder Cover Open
LED status On Line = off, Continue = off
Explanation The feeder cover is open.
Solution Close the cover to clear the error.
o Insert sss
LED status On Line = off, Continue = off
Explanation Feed device indicated by sss is open. (Where sss is Printing
menu's Paper Source value [provided that value is other than
"Auto" or "MP"].
Solution Close the indicated device.
o uuuu Toner Out
LED status On Line = off, Continue = off
Explanation The printer detected that one or more Toner Cartridges is empty
and needs to be replaced. The uuuu area identifies which Toner
Cartridge is empty, Y M C or K. Printing stops since continuing to
print without toner may cause damage to the engine.
Solution Open the front cover, replace the empty Toner Cartridge with a
new one, and close the cover to clear the error.
o Replace Photocondctr
LED status On Line = off, Continue = off
Explanation The engine has detected that the photoconductor has expired.
Printing stopped.
Solution Open the front cover, replace the photoconductor unit with a new
one, and close the cover. Then turn the printer off and back on.
Rev. B
5-5