Wiring Diagram - §9 - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000
A.3.3.9 Wiring Diagram - §9
Table A-30. Wiring Diagram - §9
Signal Name
[1] SIZE SWITCH Signal to detect the size of the paper in Tray 1.
(Analog)
[1] FEED SOLENOID ON (L) Control signal to turn the Feed Solenoid ON/OFF in
24VDC Tray 1.
[1] TRAY PAPER SENSED (L) Signal from the Tray No Paper Sensor to detect the
5VDC paper in Tray 1. (High: No paper/Low: Paper in the
tray)
[1] LOW PAPER SENSED (L) Signal from the Low Paper Sensor to detect low
5VDC paper level in Tray 1. (High: Enough paper/Low:
Low paper level)


Feed Solenoid coil resistance: 90


Size Switch signal
The paper size in the paper tray is determined by the Paper Size
Switch ON/OFF. (The Paper Size Switch is on the Size Switch
Assembly). The following table gives the paper sizes, Paper Size
Switch states (ON/OFF) and the switch voltages.
NOTE:The Paper Size Switches are defined as SW1, SW2,
SW3 and SW4 (viewed from the front of the printer). It is
defined that ON: 1 and OFF:0.
Chapter A APPENDIX
Description
10% (20 C)
Table A-31. Size Switch Signal
Paper size
SW1
No paper tray 0
B5 (LEF) *1
1
EXECUTIVE (LEF) *2
A4 (LEF) 0
LETTER (LEF) 1
A4 (SEF) *1
0
LETTER (SEF) *2
LEGAL 14" (SEF) 1
B4 (SEF) 0
A3 (SEF) 0
LEDGER (SEF) 0
12" x 8" (SEF) 0
Irregular 1
<Not used> 1
<Not used> 1
<Not used> 0
<Not used> 1
<Not used> 1
NOTE: If the ON/OFF state is the same for the Paper Size Switches,
one of the following is selected depending on the specifications
of the printer.
*1: The mm (millimeter) unit specification
*2: The inch unit specification
Paper Size Switch
Voltage
(Unit: V DC)
SW2 SW3 SW4
0 0 0 0.275~0.293
1 0 0 3.671~3.715
1 0 0 1.396~1.445
0 1 0 3.098~3.152
1 1 1 2.248~2.298
1 1 0 4.247~4.276
1 0 1 1.680~1.730
0 1 0 0.834~0.871
0 1 1 1.116~1.157
0 0 1 0.554~0.583
1 1 1 4.537~4.554
0 0 0
0 0 1
1 1 0
0 1 1
1 0 1
Rev. B
-
-
-
-
-
A-49