Sending/Receiving Commands/Statuses - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

4.2.4.3 Sending/receiving commands/statuses

NOTE: A command must be sent after the communication has been
established.
NOTE: For details, Section 4.2.7 "Commands/Status List" in this
section.
[Selecting from the pull-down menu]
NOTE: Some command codes and parameter codes are not displayed
in the pull-down menu.
1. Click the [Manual] tab. The Manual screen appears.
2. Establish the communication. (See Section 4.2.4.2 "Setting up the
Communication".)
3. Click the [Class] box. Select the category that has the command you
want to send. (There are four categories, described in Section
4.2.2.3 "Command/Status categories".)
4. Select the command code that you want to send from the command
code list.
5. The selected command code is displayed in the [Command] box.
Chapter 4 DIAGNOSTICS

A single click only displays the command code in the
[Command] box.

A double-click displays the command code in the [Command]
box; if the selected command code has a parameter, the
appropriate parameter code is also displayed.
Rev. B
4-10