Oil Cam Solenoid Removal (Pl9.3.21) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.12.14 OIL CAM SOLENOID Removal (PL9.3.21)

1. Remove the EXIT TRAY ASSEMBLY. (See Section 3.2.13.1.)
2. Remove the OIL ROLL ASSEMBLY. (See Section 3.2.12.1.)
3. Remove the FUSER ASSEMBLY. (See Section 3.2.12.2.)
4. Remove the MAIN FUSER ASSEMBLY. (See Section 3.2.12.3.)
NOTE: In the following step, FUSER REAR RAIL will be kept
connected to the FUSER TRAY ASSEMBLY. Do not move
the FUSER REAR RAIL too far from the FUSER TRAY
ASSEMBLY.
5. Remove 2 screws (gold, tapped, 10mm) securing the FUSER REAR
RAIL, and separate the FUSER REAR RAIL from the FUSER TRAY
ASSEMBLY.
6. Disconnect the connector (P/J73) for the OIL CAM SOLENOID and
release the harness from the clamp.
7. Remove 2 screw (gold, tapped, 10mm) securing the OIL CAM
SOLENOID and remove the OIL CAM SOLENOID.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-106. OIL CAM SOLENOID Removal
n When installing the OIL CAM SOLENOID, make sure
the arm on the OIL CAM SOLENOID lines up with the
T-shaped protrusion on the OIL CAM ASSEMBLY.
n After installing the OIL CAM SOLENOID, ensure that
the protrusion on the OIL CAM ASSEMBLY stays in
contact with the arm on the OIL CAM SOLENOID.
Revision B
3-89