Heat Roll Removal (Pl9.2.12) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.12.10 HEAT ROLL Removal (PL9.2.12)

1. Remove the EXIT TRAY ASSEMBLY. (See Section 3.2.13.1.)
2. Remove the OIL ROLL ASSEMBLY. (See Section 3.2.12.1.)
3. Remove the FUSER ASSEMBLY. (See Section 3.2.12.2.)
4. Remove the MAIN FUSER ASSEMBLY. (See Section 3.2.12.3.)
5. Remove the FUSER UPPER ASSEMBLY. (See Section 3.2.12.4.)
6. Remove the H/R HEATER. (See Section 3.2.12.5.)
7. Open the UPPER GUIDE ASSEMBLY.
8. Release the nuts securing the front and rear NIP SPRINGs.
9. Remove the NIP SPRINGs.
10. Remove the H/R RING securing the rear H/R GEAR and remove the
rear H/R GEAR and the REAR H/R BEARING.
11. Remove the front H/R RING and remove the front H/R BEARING.
NOTE: In the following step, be careful not to damage the HEAT
ROLL surface.
12. Shift the HEAT ROLL backward to release the front end from the
frame. Then shift the roll forward and remove the HEAT ROLL.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-102. HEAT ROLL Removal
n After installing the HEAT ROLL, perform the
adjustment "NIP adjustment of the MAIN FUSER
ASSEMBLY". (See Section 3.3.1.)
Revision B
3-85