Epson ColorPage EPL-C8000 Service Manual page 320

EPSON EPL-C8000


SSENG status parameters
NOTE:The following parameters have been defined by bits.
Table 4-55. SSENG Status Parameters
SSENG status code: C0
Data
STSMODE
(Bit)
7 -
6 DIAG TEST mode
5 WARM UP mode
Acknowledge Print
4
Quality mode
3 READY mode
2 PRINTING mode
1 ERROR mode
0 -
Chapter 4 DIAGNOSTICS
STSMODE2 STSCALL
Consumable error
LIGHT SLEEP
mode
-> (SSCONS command: C1)
DEEP SLEEP No paper -> (SSTRAY
mode command: C2)
CRUM error -> (SSCRUM
-
command: C3)
Paper jam -> (SSJAM
-
command: C4)
Hardware error -> (SSHW
-
command: C5)
Life over -> (SSLIFE
-
command: C6)
Cover open -> (SSOPEN
-
command: C7)
Warning -> (SSWARN
-
command: C8)


SSCONS/SSTRAY/SSCRUM status parameters
NOTE:The following parameters have been defined by bits.
Table 4-56. SSCONS/SSTRAY/SSCRUM Status Parameters
SSCONS status code: C1
SSTRAY status code: C2
SSCRUM status code: C3
Data
STSCONS
(Bit)
7 No Yellow toner
6 No Magenta toner
5 No Cyan toner
4 No Black toner
Full Waste Toner
3
Box
2 No Fuser Oil
1 -
0 -
STSTRAY STSCRUM
No paper in
Communication error
Cassette 1
No paper in
Verification error
Cassette 2
No paper in Used Drum Cartridge was
Cassette 3 installed.
No paper in MSI ID error
No paper in
Count error
Cassette 4
- Dummy error 1
- Dummy error 2
- -
Rev. B
4-50