Transfer Assembly Removal (Pl8.1.3) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.11.2 TRANSFER ASSEMBLY Removal (PL8.1.3)

1. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
2. Remove the REAR COVER ASSEMBLY. (See Section 3.2.4.5.)
3. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
4. Remove the TENSION LEVER. (See Section 3.2.11.1.)
5. Remove the INNER COVER ASSEMBLY. (See Section 3.2.4.4.)
6. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
7. Draw out the MAIN P/H ASSEMBLY and remove it along with the
MSI ASSEMBLY. (See Section 3.2.8.1.)
8. Remove the ROS ASSEMBLY. (See Section 3.2.9.3.)
9. Remove the ADC SENSOR ASSEMBLY. (See Section 3.2.9.4.)
10. Remove the XL RAIL ASSEMBLY. (See Section 3.2.9.5.)
11. Remove the HVPS. (See Section 3.2.16.2.)
12. Install the TENSION LEVER and turn it to the unlocking position,
then remove the lever again.
13. Release the 1ST BTR WIRE and the CONTACT ROLL WIRE from
the clamp and leave it on the inner side of the frame.
14. Disconnect the connector (P/J57) for the TRO SENSOR.
15. Loosen the screw (gold, with a washer, 8mm) securing the AUGER
HIGH ASSEMBLY at the back of the printer, and shift the AUGER
HIGH ASSEMBLY right. Then fasten the screw back to fix the
AUGER HIGH ASSEMBLY.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-77. TRANSFER ASSEMBLY Removal (1/2)
16. Remove 2 screws (black, cup head, 12mm) securing the
TRANSFER ASSEMBLY by the rear end.
17. Remove the KL clip securing the SLIDE COLLAR at the front end of
the TRANSFER ASSEMBLY.
NOTE: In the following step, note the points below.
n Never get other parts come in contact with the IBT BELT
ASSEMBLY.
n Never touch the IBT BELT surface with your hands.
n Do not catch the wire in other parts such as frames.
n Place the removed TRANSFER ASSEMBLY on a piece of paper
spread on a flat level surface.
n To protect the IBT BELT ASSEMBLY, you can cover the both
right and left frames in the TRANSFER ASSEMBLY with paper.
Revision B
3-67