Exchange Chute Removal (Pl9.3.10) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.12.13 EXCHANGE CHUTE Removal (PL9.3.10)

1. Remove the EXIT TRAY ASSEMBLY. (See Section 3.2.13.1.)
2. Remove the OIL ROLL ASSEMBLY. (See Section 3.2.12.1.)
3. Remove the FUSER ASSEMBLY. (See Section 3.2.12.2.)
4. Remove the MAIN FUSER ASSEMBLY. (See Section 3.2.12.3.)
5. Remove the EXCHANGE SPRING from the EXCHANGE CHUTE.
6. Remove the screw (gold, tapped, 10m) securing the EXCHANGE
STOPPER-F, and then remove the EXCHANGE STOPPER-F.
7. Remove the screw (gold, tapped, 10mm) securing the EXCHANGE
STOPPER-R, and then remove the EXCHANGE STOPPER-R.
NOTE: In the following step, be careful not to break the front and
rear hinges in the EXCHANGE CHUTE.
8. Remove the EXCHANGE CHUTE by taking it out to the right
horizontally.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-105. EXCHANGE CHUTE Removal
When installing the EXCHANGE CHUTE, fit the notch at
the rear end of the EXCHANGE CHUTE in the plunger in
the EXCHANGE SOLENOID.
Revision B
3-88