Epson ColorPage EPL-C8000 Service Manual page 127

EPSON EPL-C8000
3. Belt Cleaner Assembly end of life detection
(a) End of life detection
The life of the Belt Cleaner Assembly is determined by the
number of printings (number of belt cleanings). By accumulating
cleaning counts, the life of the Belt Cleaning Assembly
(Cleaning Blade) life is determined. The conditions for Belt
Cleaner Assembly end of life detection is as defined in the
following table:
Table 2-16. IBT Cleaner End Of Life Detection
Belt Cleaner Assembly end of life warning
(Maintenance-call error xxxx)
Belt Cleaner Assembly life - exceeded
(Service-call error: E0023)
NOTE:
The count described above is based on the following:
1 count:
- Each print of the two prints on one belt surface (2-UP mode)
2 counts:
- One print in 1-UP mode,
- One print on one belt surface (2-UP mode).
Chapter 2 OPERATING PRINCIPLES
98,000 counts (standard)
100,000 counts (standard)
(b) Processes after replacement
Do the following operations after you replace the
Belt Cleaner Assembly with a new one. Doing any of
these operations before replacing the Belt Cleaner
Assembly may result in damage to the system or
cause the system to malfunction.
• Life expectancy exceeded
After replacing the 2nd Belt Cleaner Assembly with a new
one, perform "IBT Cleaner Reset" in the maintenance menu.
• End of life warning
After replacing the 2nd Belt Cleaner Assembly with a new
one, perform "IBT Cleaner Reset" in the maintenance menu.
Rev. B
2-66