Epson EPL-5700 Setup Manual
Epson epl-5700: install guide
Hide thumbs
Also See for EPL-5700:
- Reference manual (221 pages) ,
- Service manual (128 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Epson EPL-5700
Summary of Contents for Epson EPL-5700
-
Page 2: Table Of Contents
Contents Introduction Unpack the Printer Attach the Paper Tray Connect the Printer Install the Software For Macintosh For Windows 98 with USB Connection For Windows with Parallel Connection Print a Test Page System Requirements Safety Instructions Additional Precautions Where to Get Help... -
Page 3: Introduction
Introduction Follow each of these steps in this guide to get your EPSON EPL-5700i up and running: Unpack the Printer Attach the Paper Tray Connect the Printer Install the Software Also be sure to check the System Requirements and follow all the Safety Instructions in the back of this guide. -
Page 4: Unpack The Printer
Make sure you have Setup a USB or parallel Guide cable to connect the printer to your computer. printer Unpack the printer from its box and check for these items: Printer Software CD-ROM Reference Guide paper tray Remove these two strips of tape:... - Page 5 Pull the tab straight out as shown below. Lift the front edge of the printer and pull firmly to remove the tab. Place the printer near your computer and an available grounded outlet, but avoid areas: •...
-
Page 6: Attach The Paper Tray
Remove any protective tape you see on the paper tray. Then lift off the cover and set it aside. Insert the paper tray into the printer as shown. Push it all the way in until it locks. Slide the blue paper guides apart. Then load a stack of paper (no more than 150 sheets). - Page 7 Place the cover on the paper tray. Raise the output tray extension until you feel it lock.
-
Page 8: Connect The Printer
Make sure the printer and computer are turned off. Plug the power cord into the back of the printer. Then plug the other end into a grounded electrical outlet. - Page 9 Connect the printer to your computer. • If you’re using a USB cable, plug the square end of the cable into your printer as shown. Then plug the other end into your computer’s USB connector or a first-tier USB hub.
-
Page 10: Install The Software
Step 4 Install the Software Follow the steps below to install the software that makes CAUTION your printer work. For Windows see page 12. For Windows with a parallel connection, see page 16. Turn off all virus protection programs before you install your For Macintosh printer software. - Page 11 Make sure your printer and computer are connected and turned off. Turn on your computer and wait until you see the desktop icons. Then turn on your EPSON printer. Insert your printer software CD-ROM. After a moment, the CD-ROM opens on your desktop.
- Page 12 After installing the printer software, you need to select your printer in the Chooser: When background printing is on, you can continue to use your Macintosh while it is preparing a document for printing. Make sure your printer is on.
- Page 13 To make sure your printer is installed correctly, you can print a test page: With the Chooser open, click Setup. Click Status Sheet. To print the status sheet, click Status Sheet. After the status sheet prints, close the Chooser.
-
Page 14: For Windows 98 With Usb Connection
USB Connection Make sure your printer and computer are connected and turned off. Turn on your computer and printer, and wait until you see the Add New Hardware Wizard: Insert your printer software CD-ROM and click Next. You see the following screen:... - Page 15 Select Search for the best driver for your device and click Next. You see the following screen: Select Specify a location, then click Browse to locate the Win98 folder on your CD-ROM. Click Next. Windows finds the USB software.
- Page 16 Click Next. Windows finishes installing the USB software. At the final screen, click Finish. Windows detects your printer and displays the following screen:...
- Page 17 When installation is complete, remove the CD-ROM from your CD-ROM drive. Restart your system. If you want to test your printer to make sure it’s installed correctly, go to “Print a Test Page” on page 18.
-
Page 18: For Windows With Parallel Connection
Turn on your computer and wait until you see the Windows desktop icons, then insert your printer software CD-ROM. Double-click the My Computer icon on your desktop, double-click the then double-click Setup.exe. You see the EPSON Printer Utility Setup screen: Epson CD-ROM icon,... - Page 19 OK. When installation is complete, you see the following: Click OK. Remove the CD-ROM from your CD-ROM drive. Restart your system. If you want to test your printer to make sure it’s installed correctly, continue on to the next section.
-
Page 20: Print A Test Page
Print a Test Page To make sure your printer is installed correctly, you can print a test page by following these steps: If you are running ® Windows NT , click Document Defaults instead of Properties. Make sure your printer is turned on. -
Page 21: System Requirements
For USB connection: a computer running Windows 98 with a Windows 98 compliant USB port and a shielded USB “AB” cable from Series A (computer) to Series B (printer), up to 6.5 feet (2 meters) long ®... -
Page 22: Safety Instructions
Safety Instructions Follow these precautions when operating your printer: Laser Safety This printer is certified as a Class 1 laser product under the U.S. Department of Health and Human Services (DHHS) Radiation Performance Standard according to the Radiation Control for Health and Safety Act of 1968. This means that the printer does not produce hazardous laser radiation. -
Page 23: Laser Safety Labels
Use of controls, adjustments, or performance of procedures other than those specified in this guide may result in hazardous radiation exposure. Your printer is a Class 1 laser product as defined in IEC 825 specifications. The label shown below is attached in countries where required. -
Page 24: Ozone Safety
Poor room ventilation • Continuous printing for a long period combined with any of the above Printer location The printer should be located so that the exhaust gases and heat generated are: • Not blown directly into the user’s face •... - Page 25 Other Safety Instructions • Be careful not to touch the fuser, which is marked CAUTION Hot Surface Avoid Contact. If the printer has been in use, the fuser can be very hot. • Avoid touching the components inside the printer unless instructed to do so in this guide.
- Page 26 Connect your printer to the correct power supply. Your printer’s power requirements are indicated on a label attached to the printer. If you are not sure of the power supply specifications in your area, contact your local power company or consult your dealer.
- Page 27 • Never spill liquid of any kind on the printer. • Except as specifically explained in this guide, do not attempt to service this product yourself. Opening or removing covers that are marked “Do Not Remove” may expose you to high voltage or other risks. Refer all servicing in those compartments to a qualified service representative.
-
Page 28: Additional Precautions
Additional Precautions To avoid damaging your printer, follow these guidelines: • Never force the printer’s components into place. Although the printer is designed to be sturdy, rough handling can damage it. • When removing the developer cartridge, never touch the developing roller under the flap; otherwise, the print quality will decline. - Page 29 If the photoconductor unit is out of the printer for a long period, covering it with an opaque cloth prevents extended exposure to light and possible damage. Exposure to light will damage the drum, resulting in dark or light areas on the printed page and may shorten the service life of the unit.
-
Page 30: Where To Get Help
EPSON Forum on Members of CompuServe can type GO ® CompuServe EPSON at the menu prompt to reach the Epson America Forum. For a free introductory CompuServe membership, call (800) 848-8199 and ask for representative #529. -
Page 31: Automated Telephone Services
• Description of the problem You can purchase cartridges, paper, manuals, and accessories from EPSON Accessories at (800) 873-7766 or visit our website at www.epsonsupplies.com (U.S. sales only). In Canada, please call (800) 873-7766 for dealer referral. If you need help using another manufacturer’s software with an EPSON product, see the documentation for that software for technical support information. -
Page 32: Declaration Of Conformity
DECLARATION of CONFORMITY According to 47CFR, Part 2 and 15 for Class B Personal Computers and Peripherals; and/or CPU Boards and Power Supplies used with Class B Personal Computers: EPSON AMERICA, INC. Located at: 20770 Madrona Avenue MS: B2-11 Torrance, CA 90503... - Page 33 SEIKO EPSON CORPORATION’s operating and maintenance instructions. SEIKO EPSON CORPORATION shall not be liable for any damages or problems arising from the use of any options or any consumable products other than those designated as Original EPSON Products or EPSON Approved Products by SEIKO EPSON CORPORATION.