Rotary Frame Assembly Removal (Pl7.2.2) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.10.5 ROTARY FRAME ASSEMBLY Removal (PL7.2.2)

1. Remove the FRONT COVER ASSEMBLY. (See Section 3.2.4.1.)
2. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
3. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
4. Remove the TENSION LEVER. (See Section 3.2.11.1.)
5. Remove the INNER COVER ASSEMBLY. (See Section 3.2.4.4.)
6. Remove the REAR COVER ASSEMBLY. (See Section 3.2.4.5.)
7. Remove all Toner Cartridges. (See Section 3.2.10.1.)
8. Remove the FRONT COVER SWITCH L. (See Section 3.2.16.8.)
9. Remove all Developer Assemblies. (See Section 3.2.10.2.)
10. Remove the ROTARY SENSOR. (See Section 3.2.10.4.)
11. Remove the FUSER ASSEMBLY with the EXIT TRAY ASSEMBLY
and OIL ROLL ASSEMBLY installed. (See Section 3.2.12.1.)
12. Remove the EXIT UPPER ASSEMBLY. (See Section 3.2.13.2.)
13. Remove the EXIT LOWER ASSEMBLY. (See Section 3.2.13.3.)
14. Remove the P/H MOTOR ASSEMBLY. (See Section 3.2.14.2.)
15. Remove the ROTARY MOTOR PWB. (See Section 3.2.14.3.)
16. Remove the ROTARY MOTOR ASSEMBLY. (See Section
3.2.14.4.)
17. Remove the DISPENSE MOTOR ASSEMBLY. (See Section
3.2.14.5.)
Chapter 3 Disassembly and Assembly/Adjustment
18. Remove the LVPS. (See Section 3.2.16.1.)
19. Remove the FUSER DRIVE ASSEMBLY. (See Section 3.2.14.6.)
20. Remove the DEVE. CLUTCH ASSEMBLY. (See Section 3.2.14.9.)
21. Remove the DEVE. TIE PLATE. (See Section 3.2.15.1.)
22. Remove the screw (black, cup head, 8mm) securing the ROTARY
KNOB ASSEMBLY.
23. Using a standard driver, remove the ROTARY KNOB ASSEMBLY.
Figure 3-71. ROTARY FRAME ASSEMBLY Removal (1/2)
Revision B
3-62