Btr Cam Solenoid Removal (Pl8.1.15) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.11.3 BTR CAM SOLENOID Removal (PL8.1.15)

1. Remove the REAR COVER ASSEMBLY. (See Section 3.2.4.5.)
2. Remove the HVPS. (See Section 3.2.16.2.)
3. Disconnect the connector (P/J63) for the BTR CAM SOLENOID and
release the harness from the clamp.
4. Remove the screw (gold, 6mm) securing the BTR CAM SOLENOID
and remove the BTR CAM SOLENOID.
Figure 3-80. BTR CAM SOLENOID Removal
Chapter 3 Disassembly and Assembly/Adjustment
When installing the BTR CAM SOLENOID, make sure it
is under the following condition:
n The arm of the BTR CAM SOLENOID is in induced
condition.
n The lower end of the arm is in contact with the
Spring Clutch in the BTR CAM ASSEMBLY.
Figure 3-81. BTR CAM SOLENOID Installation
Revision B
3-69