H/R Heater Removal (Pl9.2.20) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.12.5 H/R HEATER Removal (PL9.2.20)

1. Remove the EXIT TRAY ASSEMBLY. (See Section 3.2.13.1.)
2. Remove the OIL ROLL ASSEMBLY. (See Section 3.2.12.1.)
3. Remove the FUSER ASSEMBLY. (See Section 3.2.12.2.)
4. Remove the MAIN FUSER ASSEMBLY. (See Section 3.2.12.3.)
5. Remove the FUSER UPPER ASSEMBLY. (See Section 3.2.12.4.)
6. Supporting the terminal part in the front part of the H/R HEATER
with a driver or equivalent, remove the FUSER FRONT COVER and
place it inside the HEAT ROLL carefully.
NOTE: In the following step, avoid damaging the H/R HEATER and
the P/R HEATER when disconnecting the connector (P/
JF791) which is tightly connected.
7. Release the wire and harness from the hook on the FUSER REAR
COVER and disconnect the connector (P/JF791) for the P/R
HEATER and the H/R HEATER.
NOTE: In the following step, gear will be released as the FUSER
REAR COVER is removed. Be careful not to drop and lose
the gear.
8. Remove the FUSER REAR COVER getting the rear terminals of the
P/H HEATER and H/R HEATER through the holes in the cover.
NOTE: In the following step, do not touch the H/R HEATER surface
when removing the H/R HEATER.
9. Pull out the H/R HEATER to the rear keeping it level.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-97. H/R HEATER Removal
Revision B
3-81