Installing The Diagnostic Commander; Uninstalling The Diagnostic Commander - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

4.2.3.2 Installing the Diagnostic Commander

The following describes how to install the Diagnostic Commander:
1. Start Windows 95. Select [Settings] from the [Start] menu. Select
[Control Panel] in [Settings].
2. Double-click the [Add/Remove Programs] icon in the [Control Panel]
window.
3. Insert the Diagnostic Commander installation disk "DIAG. TOOL-1
Disk 1" in the floppy disk drive.
4. Click [Setup (I)] button in the [Add/Remove Programs Properties]
window.
5. Follow the instructions and install the Diagnostic Commander.
6. Select [Renoir Service Commander V2.01]
7. From the SELF TRAINING KIT CD, select TOOL>DIAG>Disk3>
XXXX.DAT. Then copy the selected XXXX.DAT file to the DAT
folder under the folder in which you installed Diagnostic
Commander.
Chapter 4 DIAGNOSTICS

4.2.3.3 Uninstalling the Diagnostic Commander

The following describes how to uninstall the Diagnostic Commander in
the computer.
1. Start Windows 95. Select [Settings] from the [Start] menu. Select
[Control Panel] in [Settings].
2. Double-click the [Add/Remove Programs] icon in the [Control Panel]
window.
3. Select [Renoir Service Commander V2.01] in the [Add/Remove
Programs Properties] window. Click the [Add/Remove (R)] button.
4. Follow the instructions and complete uninstalling the program.
NOTE:The RS-232C cable must be the correct cable for the DIP
switch setting on the Diagnostic PWB and the connector. The
cable must be properly shielded and the length must be 2
meters or shorter.
Rev. B
4-7