Process Drive Assembly Removal (Pl11.1.10) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.14.8 PROCESS DRIVE ASSEMBLY Removal (PL11.1.10)

1. Remove the TOP COVER ASSEMBLY. (See Section 3.2.4.3.)
2. Remove the REAR COVER ASSEMBLY. (See Section 3.2.4.5.)
3.Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
4. Remove the TENSION LEVER. (See Section 3.2.11.1.)
5. Remove the INNER COVER ASSEMBLY. (See Section 3.2.4.3.)
6. Remove the MSI TRAY ASSEMBLY. (See Section 3.2.7.1.)
7. Remove the MAIN P/H ASSEMBLY with the MSI ASSEMBLY
installed on it. (See Section 3.2.8.1.)
8. Remove the ROS ASSEMBLY. (See Section 3.2.9.3.)
9. Remove the ADC SENSOR ASSEMBLY. (See Section 3.2.9.4.)
10. Remove the XL RAIL ASSEMBLY. (See Section 3.2.9.5.)
11. Remove the HVPS. (See Section 3.2.16.2.)
12. Remove the TRANSFER ASSEMBLY. (See Section 3.2.11.2.)
13. Remove the P/H DRIVE ASSEMBLY. (See Section 3.2.14.1.)
14. Remove the P/H MOTOR ASSEMBLY. (See Section 3.2.14.2.)
15. Remove the screw (black, cup head, 8mm) securing the HVPS
BRACKET-1, and remove the HVPS BRACKET-1 along with 2
ELEC. CLAMP-Ss.
16. Disconnect 2 connectors (P/J51 and P/J52) for the PROCESS
MOTOR ASSEMBLY and release the harnesses from the clamp.
Chapter 3 Disassembly and Assembly/Adjustment
17. Remove 7 screws (black, cup head, 8mm) securing the PROCESS
DRIVE ASSEMBLY and remove the PROCESS DRIVE
ASSEMBLY.
Figure 3-133. PROCESS DRIVE ASSEMBLY Removal
When installing the PROCESS DRIVE ASSEMBLY,
make sure the location hole in the PROCESS DRIVE
ASSEMBLY fits in the protrusion on the base frame.
Revision B
3-108