Epson ColorPage EPL-C8000 Service Manual page 473

EPSON EPL-C8000
A.1 Parts List
This chapter describes the printer parts. The parts are grouped into 14
major plates. These plates are divided further into the following 27
smaller plates. Each plate has an illustration and a corresponding parts
list.
* PL1.1 Cover
* PL2.1 Paper Tray I
* PL2.2 Paper Tray II
* PL3.1 Paper Feeder
* PL4.1 Multi Sheet Inserter I
* PL4.2 Multi Sheet Inserter II
* PL4.3 Multi Sheet Inserter III
* PL5.1 Paper Transportation I
* PL5.2 Paper Transportation II
* PL6.1 Xerographics
* PL7.1 Development I
* PL7.2 Development II
* PL8.1 IBT I
* PL8.2 IBT II
Chapter A APPENDIX
* PL8.3 IBT III
* PL8.4 IBT IV
* PL9.1 Fusing I
* PL9.2 Fusing II
* PL9.3 Fusing III
* PL9.4 Fusing IV
* PL10.1 Paper Exit I
* PL10.2 Paper Exit II
* PL11.1 Drive
* PL12.1 Frame
* PL13.1 Electrical I
* PL13.2 Electrical II
* PL14.1 Controller
A.1.1 How to Use the Part List
Followings are the points to note when using the part list and exploded
diagrams.
• The numbers in each illustration correspond to the parts list number for
that illustration.
• PL "X.Y.Z" indicates part Z in Plate "X.Y."
• The capital letters shown in the illustrations stand for the following:
S: screw
E: E ring
KL: KL clip
C: C ring
N: nut
• The arrowheads in the illustrations indicate assemblies made up of
lower parts with their numbers.
• A circled capital letter is connected to the same circled capital letter in
the illustration.
• A "with 2-5" in the illustrations or list shows that the part includes items
2, 3, 4 and 5. A "with 2-5, PL6.1.1" shows that the part includes items 2,
3, 4 and 5 of the plate and also includes item 1 of plate 6.1.
• An asterisk (*) indicates that there is a note about the part on the same
page.
NOTE: For spare parts, see the Spare Parts List (published separately).
NOTE: For harness and wire connectors (P/J), see Section A.3 "Wiring
Diagrams".
Rev. B
A-1