Installing Additional Memory; Introduction; Tools Required; Installation Basics - HP NetServer E 60 Installation Manual

5 Installing Additional Memory

Introduction

The NetServer E 60's main memory is implemented with 3.3V, 100 MHz,
unbuffered SDRAM DIMMs (Dual In-Line Memory Modules). The NetServer
E 60 ships with at least 64 MB of main memory and supports up to 1 GB.
Memory is available in the following DIMM capacities: 64, 128, and 256 MB.

Tools Required

Use an anti-static service kit (3M™ 8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist strap.

Installation Basics

There are four DIMM sockets on the system board. See Figure 5-1 for socket
location. DIMMs may be installed in any combination in any socket. However,
HP recommends starting at socket 0 and filling the sockets in order: 1, 2, and 3.
Use only HP DIMMs. For availability of DIMM upgrade kits for the NetServer
E 60, check the web site at:
http://www.hp.com/netserver/products/accessories/

Installing Additional DIMMs

1. If the system is already installed and working, gracefully power down the
system as described in Chapter 2.
2. Disconnect the power cables and any external cables connected to the
system. If necessary, label them to expedite reassembly.
3. Remove the cover and turn in the system feet (so that the system will lay
flat on its side) as described in Chapter 3.
WARNING The power supply will continue to provide standby current to
the NetServer E 60 until the power cable is disconnected.
29