Table of Contents
Advertisement
USER'S GUIDE
3.
To add any additional static routes, click on Add. You will see a screen similar to the following:
4.
Select the Destination Subnet Name from the list of previously configured subnets. This is the
static route's destination subnet. If this will be the site's default route, select <DEFAULT
ROUTE>.
5.
If this static route is over a WAN UnNumbered interface:
a.
Make sure a check appears next to Use WAN UnNumbered Interface.
b. Select the Next Hop Site Name. This is the device that is the next hop gateway that provides
access to the destination subnet.
6.
If this static route is over a WAN Numbered interface:
a.
Make sure no check appears next to Use WAN UnNumbered Interface.
b. Enter a Next Hop Address. This is an IP address using dotted decimal notation for the next
hop gateway that provides access to the destination subnet.
7.
Enter the Metric value. Refer to
8.
Select the RIP Propagation control. Refer to
9.
Click OK. Repeat steps 3 through 9 to add any additional static routes for this system.
C
IP F
ONFIGURING
IP Filters allow you to control the admission and transmission of individual IP datagrams based on
the datagram's contents.
118
SFVRA Configuration Manager
page 111
ILTERS
for a metric value definition.
page 111
for a RIP propagation control definition.
Advertisement
Table of Contents
