Network Address - Cabletron Systems CSMIM-T1 Quick Start Manual

The Remote Annex 2000 uses port 1 as its console port.
The Remote Annex 539x uses the service port on the 5000 chassis
as the console port.
3 Set the terminal to 9600 bps, 8 bits, 1 stop bit, no parity and no
flow control.
4 For the Remote Annex 2000 or Remote Annex 4000, turn on the
unit and immediately press the
Make sure the Test LED comes on.
For the Remote Annex 539x, Remote Annex 6100 and Remote
Annex 6300, turn on the unit and immediately press the
button. Make sure the Setup LED comes on.
5 If the LED next to the

Network Address

After the Remote Annex runs a series of hardware diagnostics, the terminal
displays the monitor prompt. Enter address information (step 1) and, if you
purchased a LAT key, the LAT key value (step 2).
Step 1 procedures are slightly different for the Remote Annex 6300.
is 192.9.200.55.
1 Enter addr and answer the prompts as shown in the example. To
accept the default shown in brackets, press the
monitor:: addr
Enter Internet address [<invalid or uninitialized>]::
192.9.200.62
Enter Subnet mask [255.255.255.0]::
Enter preferred load host Internet address [<any host>]::
192.9.200.55
Preferred load host address: 192.9.200.55
Enter Broadcast address [0.0.0.0]::
Preferred dump address [0.0.0.0]::
4
For illustration purposes, sample response values
indicate a Remote Annex on an Ethernet network with
the IP address 192.9.200.62. The host system address
Remote Annex Quick Start for Windows
button on the front panel.
Test
button is not lit, press
Test
Setup
again.
Test
key.
Return