Table of Contents
Advertisement
C
D
ONFIGURING
EFAULT
This section shows you how to configure default line protocol information for the site template. The
screen below shows the initial default line protocol configuration.
When a connection occurs, the system waits for a packet to arrive, and from that packet, it
determines the protocol type being used. After a default frame timeout value of 30 seconds, if no
packet is received, the default action on frame timeout is to disconnect the call. Through the Default
Line Protocol dialog box (as shown above), you may change the default action and default timeout
value.
1.
Select the Action on Frame Timeout. This is the action to be taken if no frame is received before
the configured frame timeout value has expired. Possible actions are:
•
Disconnect
•
Use HDLC Bridge Protocol
•
Use IP Host Protocol (RFC 1294)
•
Use PPP Protocol
2.
Enter the Frame Timeout Value. This is the time limit (in seconds) to wait to receive a packet.
L
P
I
INE
ROTOCOL
NFORMATION
C
S
ONFIGURING
ITE
Configuring Template Options
SFVRA Configuration Manager
T
EMPLATES
59
Advertisement
Table of Contents
