Map 600: Event Codes - HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual

Table 11: MAP 600: Event Codes (Continued)
Event
Code
584
585
586
4
Is fault isolation being performed at the switch?
YES
5
Each port has an amber and green LEDs next to the ports. The amber LED
illuminates and the green LED extinguishes if the port fails.
Are an amber port LED and the amber LED illuminated but not blinking
(beaconing)?
YES
6
A Fibre Channel port failed, and the SFP optical transceiver must be removed and
replaced
This procedure is concurrent and can be performed while switch power is on:
Edge Switch 2/24 Service Manual
Not operational primitive sequence
received.
Primitive sequence timeout.
Invalid primitive sequence received for
current link state.
NO
Fault isolation is being performed at the HAFM server (or
customer-supplied server) or EWS interface.
Go to step 7.
NO
The switch appears operational, however a link incident or other
problem may have occurred. Perform fault isolation at the HAFM
server (or customer-supplied server). Go to
("RRP 1: SFP Optical
a. Verify location of the failed port.
b. Replace the optical transceiver with a transceiver of the same type
(shortwave or longwave).
c. Perform an external loopback test for the port as part of FRU removal and
replacement.
Explanation
Transceiver" on page 175).
Diagnostics
Action
Go to step 25.
Go to step 25.
Go to step 25.
step 12.
95