HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 202

Messages
Table 25: HAFM application messages (Continued)
Only attached nodes
can be displayed in
this mode.
Password and
confirmation don't
match.
Product manager
instance is currently
open.
Remote session
support has been
disabled.
Remote sessions are
not allowed from this
network address.
Resource is
unavailable.
Selection is not a
World-Wide Name.
Server shutting down.
200
Message
Users cannot display
unused ports when
adding ports by
world-wide name.
Entries in the
password field and
confirmation password
field do not match. The
entries are case
sensitive and must be
the same.
A product cannot be
deleted while an
instance of the Product
Manager application
is open.
The connection
between the specified
remote workstation
and the HAFM server
was disallowed.
Only IP addresses of
remote workstations
specified at the
Session Options
dialog box are
allowed to connect to
the HAFM server.
The specified
operation cannot be
performed because the
product is unavailable.
The selection made is
not a world-wide
name.
The HAFM application
is closing and
terminating
communication with
the attached product.
Description
Change the add criteria to Add
by Port.
Enter the password and
confirmation password again.
Close the Product Manager
application, then delete the
product.
Consult with the customer's
network administrator to
determine if the workstation
entry should be modified at the
Session Options dialog box.
Consult with the customer's
network administrator to
determine if the IP address is to
be configured for remote
sessions.
Verify the HAFM
server-to-product link is up. If
the link is up, the HAFM server
may be busy. Retry the
operation later.
Select a valid world-wide name
before performing this
operation.
Reboot the HAFM server. If the
problem persists, contact the
next level of support.
Action
Edge Switch 2/24 Service Manual