HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 101

3. Select the operating mode as follows:
4. Click Activate to save the selection and close the window.
Did configuring the operating mode solve the problem?
NO
Contact the next level of support. Exit MAP.
19
A loopback (wrap) plug is connected to the port and there is no diagnostic test
running. Is a loopback plug in the port receptacle?
YES
20
Remove the loopback plug from the port receptacle. If directed by the customer,
connect a fiber-optic jumper cable attaching a device to the switch.
Did removing the loopback plug solve the problem?
NO
Contact the next level of support. Exit MAP.
Edge Switch 2/24 Service Manual
a. Select the Interop Mode radio button to set the switch to open systems
operating mode, then select Homogeneous Fabric 1.0 or Open Fabric
1.0 from the Interop Mode list box.
b. Select the Homogeneous Fabric option if the switch is fabric-attached
only to other HP switches or switches that are also operating in
Homogeneous Fabric 1.0 mode. Select the Open Fabric option if the
switch is fabric-attached to switches or switches produced by other
original equipment manufacturers (OEMs) that are open-fabric compliant.
YES
The switch appears operational. Exit MAP.
NO
Contact the next level of support. Exit MAP.
If the port is operational and a device is not attached, both LEDs adjacent to
the port extinguish and the port state is No Light.
If the port is operational and a device is attached, the green
LED illuminates, the amber LED extinguishes, and the port state is Online.
YES
The switch appears operational. Exit MAP.
Diagnostics
101