HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 208

Messages
Table 25: HAFM application messages (Continued)
Zones configured with
port numbers are
ignored in Open
Fabric Mode.
Zones must be defined
before creating a zone
set.
Zoning by port
number is not
supported in Open
Fabric Mode.
Zoning name already
exists.
206
Message
While in Open Fabric
mode, zones
configured using port
numbers are enforced
through world-wide
names.
You cannot create a
zone set without any
zones defined for the
HAFM.
You cannot specify an
item for zoning by port
number if the HAFM
application is set to
Open Fabric Mode.
Duplicate zone names
are not allowed in the
zoning library.
Description
Informational message only–no
action is required.
Define zones using the New
Zone dialog box.
Either define zones by device
WWN or change to
Homogeneous Fabric 1.0
mode in the Configure
Operation Mode dialog box of
the Product Manager
application.
Modify (to make it unique) or
delete the duplicate zone
name.
Action
Edge Switch 2/24 Service Manual