HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 105

Fw 05.01.00 and sw 07.01.00 edge switch 2/24 service manual
Hide thumbs Also See for 316095-B21 - StorageWorks Edge Switch 2/24:
Table of Contents

Advertisement

28
Clean fiber-optic connectors on the jumper cable.
1. Notify the customer the port will be blocked. Ensure the customer's system
2. Block the port
3. Disconnect both ends of the fiber-optic jumper cable.
4. Clean the fiber-optic connectors
5. Reconnect the fiber-optic jumper cable.
6. Unblock the port
7. Monitor port operation for approximately five minutes.
Did the link incident recur?
YES
29
Disconnect the fiber-optic jumper cable from the switch port and connect the
cable to a spare port.
Is a link incident reported at the new port?
YES
30
The attached device is causing the recurrent link incident. Notify the customer of
the problem and have the system administrator:
1. Inspect and verify operation of the attached device.
2. Repair the attached device if a failure is indicated.
3. Monitor port operation for approximately five minutes.
Edge Switch 2/24 Service Manual
administrator quiesces Fibre Channel frame traffic through the port and sets
the attached device offline.
("Block and Unblock
page 154).
("Block and Unblock
NO
The Fibre Channel link and switch appear operational.
Exit MAP.
NO
Go to
step
31.
Ports" on page 152).
("Clean Fiber-Optic
Ports" on page 152).
Diagnostics
Components" on
105

Advertisement

Table of Contents
loading

Table of Contents