HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 98

Diagnostics
Link failure - invalid primitive sequence received for
the current link state.
Did one of the listed messages appear in the Link Incident Log?
YES
Go to
13
A Fibre Channel port failed an internal or external loopback test.
1. Reset each port that failed the loopback test.
2. Perform an external loopback test for all ports that were reset.
Did resetting ports solve the problem?
NO
14
A switch port is unblocked and receiving the offline sequence (OLS) or not
operational sequence (NOS) from an attached device.
Inform the customer that the attached device failed or is set offline. Exit MAP.
15
Beaconing is enabled for the port.
1. Consult the customer and next level of support to determine the reason port
2. Disable port beaconing.
98
NO
The switch appears operational. Exit MAP.
step 25.
a. At the Hardware View, right-click the port. A pop-up menu displays.
b. Select Reset Port. A Reset Port n message box displays, where n is
the port number.
c. Click OK. The port resets.
YES
The switch appears operational. Exit MAP.
beaconing is enabled.
a. At the Hardware View, right-click the port graphic. A pop-up menu
displays.
b. Click the Enable Beaconing option. The check mark disappears from the
box adjacent to the option, and port beaconing is disabled.
Edge Switch 2/24 Service Manual