Figure 18: Port Settings tab
8. Configure the Port Settings parameters as follows:
9. At the > prompt, type the user-level password (the default is password) and
10. At the C> prompt, type the ipconfig command and press Enter. The
Edge Switch 2/24 Service Manual
115200
Bits per second - 115200.
Data bits - 8.
Parity - None.
Stop bits - 1.
Flow control - Hardware.
When the parameters are set, click OK. The HyperTerminal window
displays.
press Enter. The password is case sensitive. The HyperTerminal window
displays with software and hardware version information for the switch, and a
C> prompt at the bottom of the window.
HyperTerminal window displays with configuration information listed
(including the IP address).
Diagnostics
83