HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 211

Table 26: Edge Switch 2/24 Product Manager Messages (Continued)
Cannot enable Open
Trunking while
Enterprise Fabric Mode
is active and the switch is
online.
Cannot have spaces in
field.
Cannot install firmware
to a switch with a failed
CTP card.
Cannot perform this
operation while the
switch is offline.
Cannot retrieve current
SNMP configuration.
Edge Switch 2/24 Service Manual
Message
Enterprise Fabric mode
is active and the switch
is online and user is
attempting to enable
Open Trunking. This
message only displays if
the optional Open
Trunking feature is
installed.
Spaces are not allowed
in this field.
Firmware cannot be
installed on a switch with
a defective CTP card.
This operation cannot
take place while the
switch is offline.
The current SNMP
configuration cannot be
retrieved. The link is
down or busy.
Description
Messages
Action
Perform either of the
following steps:
Disable Enterprise
Fabric Mode option by
selecting the
appropriate fabric in
the Fabric Tree portion
of the HAFM window
(Fabrics tab) and then
selecting Enterprise
Fabric Mode from the
Fabrics menu. When
the Enterprise Fabric
Mode dialog box
displays, click Start
and follow prompts to
disable the feature.
Set the switch offline
through the Set Online
State dialog box.
Display this dialog box
by selecting Set Online
State from the Product
Manager Maintenance
menu.
Remove the spaces or
retype the field without
spaces.
Note that the CTP card is
not a FRU. If it fails, the
switch must be replaced.
After replacement, retry the
firmware install to the
switch.
Configure the switch offline
through the Set Online
State dialog box then retry
the operation.
Retry the operation later. If
the condition persists,
contact support personnel.
209