HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 224

Messages
Table 26: Edge Switch 2/24 Product Manager Messages (Continued)
The switch is busy saving
maintenance
information.
The following
parameters cannot be
disabled while Enterprise
Fabric Mode is active:
Insistent Domain ID,
Rerouting Delay,
Domain RSCN's.
The firmware file is
corrupted.
The firmware version
already exists.
The HAFM server is busy
processing a request
from another Product
Manager
The link to the switch is
not available.
The maximum number of
address configurations
has been reached.
The optical transceiver is
not installed.
The switch did not
respond in the time
allowed.
The IPL configuration
cannot be deleted.
222
Message
The switch is busy with a
maintenance operation.
User attempted to
disable these parameters
in the Configure Switch
Parameters dialog box
while Enterprise Fabric
Mode is enabled.
A firmware file has
corrupt data.
Firmware version
already exists in the
database.
The HAFM server could
not process the current
request because it is
busy handling a request
from another Product
Manager.
The link from the HAFM
server to the switch is not
available.
The maximum number of
saved address
configurations has been
reached.
No information
available for a port that
is not installed.
A time out was reached
waiting for the switch to
respond to the action.
Deletion of the IPL
address configuration
was attempted and was
not allowed.
Description
Edge Switch 2/24 Service Manual
Action
Retry the operation later. If
the condition persists,
contact support personnel.
Disable Enterprise Fabric
Mode through the
Enterprise Fabric Mode
dialog box in the HAFM,
then disable the
parameters.
Contact support personnel.
N/A. An informational
message.
Retry the operation later. If
the condition persists,
contact support personnel.
Check Ethernet connection.
Delete configurations no
longer needed to allow
new configuration to be
saved.
Ensure the optical
transceiver is installed and
fully seated.
Try action again.
Cancel the operation.