Connection: Analog Modem - Cisco OL-4015-08 User Manual

Chapter 4 Edit Interface/Connection

Connection: Analog Modem

Encapsulation
Remote Phone Number
Options
Clear Line
IP Address
OL-4015-08
Complete these fields if you are configuring an analog modem connection.
Because SDM supports only PPP encapsulation over an analog modem
connection, the encapsulation shown is not editable.
PPP selected.
Enter the phone number of the destination of the analog modem connection.
Click this button if you need to associate ACLs with a dialer list to identify
interesting traffic or enter timer settings.
Identifying interesting traffic will cause the router to dial out and create an active
connection only when the router detects interesting traffic.
Timer settings will cause the router to automatically disconnect a call after the
line is idle for the specified amount of time.
Click this button to clear the line. You should clear the line after creating an async
connection so that interesting traffic triggers the connection.
Select either Static IP address, IP Unnumbered or IP Negotiated. If you select
Specify an IP address, complete the fields below.
IP Address
Enter the IP address for this point-to-point subinterface. Obtain this value from
your network administrator or service provider. For more information, refer to
Addresses and Subnet
Cisco Router and Security Device Manager Version 2.2 User's Guide
Masks.
Connection: Analog Modem
4-47
IP