Show Capture Packets; Dumping System Information; Setting The Output Length Of Show Running-Config; Terminal Length - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static

16.6.5 show capture packets

This command displays packets being captured from the buffer. The output of the show
command can be redirected to a text file. The resultant text file can be fed to the text2pcap
utility or the Ethereal public domain packet analyzer, which can then be translated to a cap
file
Format
Mode

16.7 Dumping System Information

The show tech-support command dumps all major system information into a file that can
be sent to NETGEAR product support for debugging purposes. The command output is
not displayed on the console. Use the copy command to transfer the dumped file to the
host PC.
Format
Mode

16.8 Setting the Output Length of show running-config

By default, the output of the show running-config command pauses after every 18 lines
of output. If you do not want the output to pause or you want to change the number of lines
displayed, the following commands are provided to control output behavior.

16.8.1 terminal length

This command specifies how many lines of output to display on the console before
pausing. When the value of 0 is used, the output will not pause.
Format
Mode
System Maintenance Commands
show capture packets
Global Config
show tech-support
Global Config
<0-24>
terminal length
Global Config
v1.0, November 2007
16-33