Cable Modem; Usb Adapter - ZyXEL Communications MWR222 - V1.0 Manual


Find out from your ISP what the "PPPoE Username and Password" are for
your Internet connection.

Once the DSL modem has been bridged, connect it (by Ethernet cord) to
the WAN port of the MWR222 (MWR222 has only one Ethernet port, and it
is configured to be a LAN port by default. So user has to change the
configuration first so that the Ethernet port can act as the WAN port. Once
this is done user can no longer use the wired connection for the web
configurator.)

Open your browser and log into the MWR222. Click on Configuration >
Network > Wired WAN, for the encryption select "PPPoE" and enter your
PPPoE "Username and Password."

8.2.2 Cable Modem

 Connect the cable modem to your MWR222 on the WAN port. (MWR222
has only one Ethernet port, and it is configured to be a LAN port by
default. So user has to change the configuration first so that the Ethernet
port can act as the WAN port. Once this is done user can no longer use the
wired connection for the web configurator.)
 Unplug the power to your cable modem. Depending on your cable modem,
it may also have a backup battery inside. Remove this battery and
completely power down the cable modem. Let it sit from 2 to 3 minutes
and then reconnect the battery and power to the cable modem.
 If the router is set with its default settings it should automatically connect
to the Internet.
8.2.3 3G USB Adapter
 Activate the 3G USB adapter on a PC first, using the software provided by
the ISP.
 Connect the 3G USB adapter to the USB1 port on the MWR222 (there is
only one USB port in MWR222 which will work, the USB2 port is for future
uses)
 Log into your MWR222 using your computer's browser.
 Click on the Configuration tab at the left side of the screen.
 Click on "Network" under the configuration tab, and then click on "WAN".
 On the WAN configuration page, click on the Mobile WAN tab at the top of
the page. Then fill in the account information you obtained from the
mobile broad band ISP. Make sure you check "Nailed-Up Connection."
MWR222 User's Guide
71