Sys Op Mode Screen - ZyXEL Communications MWR222 - V1.0 Manual

29.4

Sys Op Mode Screen

Use this screen to select how you want to use your MWR222.
Figure 126 Maintenance > Sys OP Mode
The following table describes the labels in the General screen.
Table 76 Maintenance > Sys OP Mode
LABEL DESCRIPTION
System Operation Mode
Select Router Mode if your device routes traffic between a local network
and another network such as the Internet. This mode offers services such
as a firewall or bandwidth management.
Router
You can configure the IP address settings on your WAN port. Contact
your ISP or system administrator for more information on appropriate
settings.
Select Access Point Mode if your device bridges traffic between clients
on the same network.
• In Access Point mode all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the
Access Point
port labeled WAN. There is no WAN port.
• The DHCP server on your device is disabled.
• The IP address of the device on the local network is set to
192.168.10.2.
MWR222 User's Guide
200