ZyXEL Communications MWR222 - V1.0 Manual page 207

I cannot see or access the Login screen in the Web Configurator.
Make sure you are using the correct IP address.
1
• The default IP address is 192.168.10.1.
• If you changed the IP address
address.
• If you changed the IP address and have forgotten it, see the
troubleshooting suggestions for I don't know the IP address of my
MWR222
Check the hardware connections, and make sure the LEDs are
2
behaving as expected. See the Quick Start Guide.
Make sure your Internet browser does not block pop-up windows and
3
has JavaScripts and Java enabled. See
Make sure your computer is in the same subnet as the MWR222. (If
4
you know that there are routers between your computer and the
MWR222, skip this step.)
• If there is a DHCP server on your network, make sure your computer
is using a dynamic IP address. See
• If there is no DHCP server on your network, make sure your
computer's IP address is in the same subnet as the MWR222. See
Appendix
Reset the device to its factory defaults, and try to access the MWR222
5
with the default IP address. See
If the problem continues, contact the network administrator or vendor,
6
or try one of the advanced suggestions.
Advanced Suggestion
MWR222I can see the Login screen, but I cannot log in to the
MWR222.
Make sure you have entered the password correctly. The default
1
password is 1234. This field is case-sensitive, so make sure [Caps
Lock] is not on.
This can happen when you fail to log out properly from your last
2
session. Try logging in again after 5 minutes.
Disconnect and re-connect the power adaptor or cord to the MWR222.
3
If this does not work, you have to reset the device to its factory
4
defaults. See Resetting MWR222.
MWR222 User's Guide
(Section
B.
Section
207
13.4), use the new IP
Appendix A.
Section 14.3.
28.3.